RIDGID R82001 Drill User Manual


 
12
OPERATION
TO INSTALL BATTERY PACK
n Lock the switch trigger on the drill by placing the
direction of rotation (forward-reverse) selector in center
position. See Figure 4.
n Place battery pack in the drill. Align raised rib on battery
pack with the groove inside the drill. See Figure 5.
n Make sure the latches on each side of your battery pack
snap in place and battery pack is secured in the drill
before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the slide on
the bottom of the drill and latches snap into place
properly. Improper assembly of the battery pack
can cause damage to internal components.
TO REMOVE BATTERY PACK
n Lock the switch trigger on the drill by placing the
direction of rotation selector in center position.
See Figure 4.
n Locate latches on side of battery pack and depress to
release battery pack from the drill. See Figure 5.
n The battery pack will automatically disconnect in
direction to be removed when buttons are depressed.
n Remove the battery pack from your drill.
Fig. 4
Fig. 5
DEPRESS LATCHES TO
RELEASE BATTERY PACK
SELECTOR WITH CENTER
LOCK POSITION
FORWARD
REVERSE