10
ATTACHING CIRCLE CUTTER
See Figure 4.
n Remove Battery Pack From speed saw.
n Assemble circle cutter if necessary. Refer to “Assembling
Circle Cutter.”
n Remove bit if necessary. Refer to “Inserting/Removing
Bits” in this manual.
n Place adaptor under depth adjustment ring.
NOTE: Make sure the adaptor fits snugly.
n Place circle cutter arm on top of depth adjustment ring.
n Screw threaded ring onto adaptor, securing circle cutter
arm.
n Insert bit. Refer to “Inserting/Removing Bits” in this
manual.
Fig. 4
ADAPTOR
DEPTH
ADJUSTMENT
RING
CIRCLE
CUTTER
ARM
THREADED
RING
ASSEMBLY
OPERATION
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could re-
sult in objects being thrown into your eyes, resulting in
possible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
NOTE: Most of these applications require different types of
bits. Be sure to use the right bit for your tool.
n Cutting electrical outlet openings in drywall or wood pan-
eling. It is recommended to use a 1/8 in. bit for cutting
wood paneling.
n Creating decorative wood accents
n Cutting tile
CAUTION:
To prevent damage to the battery pack, remove the
battery pack from the charger immediately if no LED
comes on. Return the battery pack and charger to your
nearest service center for checking or replacing. Also,
if you are removing the battery pack from the charger
and no LEDs are on, return both the battery pack and
the charger to your nearest service center. Do not insert
another battery pack into the charger. A damaged charger
may damage a battery pack.