Ryobi P530 Saw User Manual


 
14
WARNING: To prevent accidental starting that
could cause serious personal injury, always remove
the battery pack from the tool when making adjust-
ments.
INSERTING/REMOVING BITS
See Figure 10.
n Remove battery pack from speed saw.
CAUTION:To prevent damage to the spindle or
spindle lock, always allow motor to come to a
complete stop before engaging spindle lock.
n Depress spindle lock.
n Loosen collet nut by turning counterclockwise with the
wrench provided.
WARNING: If you are changing a bit immediately
after use, be careful not to touch the bit or collet
with your hands or fingers. They will get burned
because of the heat buildup from cutting.
Always use the wrench provided.
n To insert bit: Insert shank end of bit into collet.
n To remove bit: Remove bit once collet nut is loose.
NOTE: The collet is machined to precision toler-
ances to fit bits with 1/4 in. diameter shanks. To use
bits with 1/8 in. shank bits, insert the 1/8 in. adaptor
into the 1/4 in. collet.
n Tighten collet nut securely by turning clockwise with the
wrench provided.
WARNING: If the collet nut is not securely tightened,
t the bit may detach during use causing serious
personal injury.
n Release spindle lock.
WARNINGDo not use bits with undersized shanks.
Undersized shanks will not tighten properly and could
b be thrown from the tool causing injury.
ADJUSTING DEPTH OF CUT
See Figure 11.
n Remove Battery Pack From speed saw.
n Loosen adjusting knob by turning counterclockwise.
n Move depth adjustment ring to desired position.
n Tighten adjusting knob by turning clockwise.
Fig. 10
TO LOOSEN
Fig. 11
ADJUST UP OR
DOWN
TO LOOSEN
TO TIGHTEN
TO TIGHTEN
ADJUSTMENTS