Filter
Top Products
12
INSTALLING BATTERY PACK
See Figure 6.
n Place battery pack on the speed saw.
n Align raised rib on battery pack with groove in saw’s bat-
tery port.
n Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured on the tool
before beginning operation.
REMOVING BATTERY PACK
See Figure 6.
n Locate latches on side of battery pack and depress both
sides to release battery pack from the speed saw.
n Remove battery pack from the speed saw.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the tool
and latches into place properly. Improper installa-
tion of the battery pack can cause damage to internal
components.
STARTING/STOPPING SPEED SAW
See Figure 7.
Follow these directions when starting and stopping the
speed saw.
To start: Depress switch to the On ( I ) position.
To stop: Depress switch to the Off ( O ) position.
CAUTION:
We suggest that you practice with your speed saw before
installing a bit and making cuts.
OPERATING THE SPEED SAW
See Figure 8.
n Hold speed saw firmly with both hands.
n Start speed saw.
n Tilt speed saw at a 45
o
angle.
n Plunge bit into material using guide ring as a pivot.
n Raise speed saw slowly to a 90
o
angle.
n Begin cutting.
Fig. 8
Fig. 7
Fig. 6
BATTERY PACK
LATCHES
DEPRESS
DEPRESS
ON
OFF
OPERATION
DANGER:
Do not cut electrical outlet openings with live electrical
wires. Do not cut walls that may have live electrical
wiring behind them. Shut off breakers or remove fuses
to disconnect the circuit. Always hold the tool by its
motor housing.