Filter
Top Products
16
OPERATION
45
51.5
30
15
Fig. 15
45
51.5
30
15
USING THE LASER GUIDE
See Figure 14.
WARNING:
Do not stare into the laser beam or turn the laser on when
the tool is not in use. Failure to heed this warning could
result in possible serious personal injury.
The laser guide will generate a red laser beam on the work
surface in front of the saw when turned on. The laser aids in
following the line of cut when cutting the workpiece.
NOTE: The laser unit comes from the factory already installed
and aligned. If the laser becomes misaligned after time, refer
to the Adjustments section later in this manual.
Unplug the saw.
Mark the line to be cut on the workpiece.
Adjust the depth and angle of the cut as needed.
Plug the tool into a power supply and press the laser guide
button to activate the laser.
Start the motor.
NOTE: Do not touch the blade to the workpiece until the
saw has reached maximum speed.
Slowly push the saw forward into the workpiece.
NOTE: Keep the laser beam on the marked line on the
workpiece for precision cutting.
Once the cut is complete, allow the saw to come to a
complete stop before turning off the laser.
LED WORKLIGHT
See Figure 15.
Depress the LED worklight button to turn the LED light ON or
OFF. Always turn the light off when the saw is not in use.
LeD
wOrKLigHT
LaSer guiDe
BuTTON
PuSH iN TO
TurN ON
PuSH iN TO
TurN Off
LaSer
BeaM
Fig. 14
LeD
wOrKLigHT
BuTTON
PuSH iN TO
TurN ON
PuSH iN TO
TurN Off