Filter
Top Products
21
Fig. 26
BeVeL
aDJuSTMeNT
KNOB
BLaDe
COMBiNaTiON
SQuare
aDJuSTiNg
SCrew
Hex NuT
0° BeVeL STOP
51.5
15
30
45
OPERATION
0° BEVEL STOP
See Figure 26.
The saw has a 0° bevel stop that has been factory adjusted to
assure 0° angle of the saw blade when making 90° cuts.
To check 0° bevel stop:
Unplug the saw.
Place the saw in an upside down position on a work-
bench.
Check the squareness of the saw blade plate to the base
of the saw using a combination square.
To adjust 0° bevel stop:
Unplug the saw.
Loosen bevel adjustment knob.
Loosen hex nut securing adjusting screw.
Turn screw and adjust base until square with saw
blade.
Tighten hex nut and bevel adjustment knob securely.
WARNING:
Attempting a bevel cut without having the bevel ad-
justment knob securely tightened can result in serious
injury.