Filter
Top Products
Page 10
1
2
1
2
3
3
0
5
16
3
4
45°
90°
0
5
16
3
4
45°
90°
FENCE ORIENTATION
FOR 90° ANGLES
ADJUSTMENTS
FENCE HEIGHT ADJUSTMENT
See Figure 5.
The fence on your biscuit joiner can be moved up and down
to adjust the position of the blade in relation to the top of the
workpiece. A scale on both sides of the front base indicates
height settings for both 45° and 90° angles. The fence and
height indicator mark can be positioned from 5/16 in. to 13/16
in. from the center of the blade for 45° angles. It can be
positioned from 0 to 3/4 in. from the center of the blade for 90°
angles. Scale marks are in increments of 1/16 in.
TO ADJUST HEIGHT SETTING
See Figure 5.
■ Unplug your detail biscuit joiner.
WARNING:
Failure to unplug your detail biscuit joiner could result in
accidental starting causing possible serious personal
injury.
■ Loosen the two height adjustment knobs.
■ Pull the fence forward and slide it up or down until the
height indicator mark is aligned with the desired dimen-
sion on the scale.
NOTE: Slots in the front base align with a tab on the
backside of the fence.
See Figure 6.
This alignment
keeps the fence square at each height setting.
■ Tighten height adjustment knobs securely.
FENCE ROTATION / ANGLE ADJUSTMENT
See Figure 6.
The fence on your biscuit joiner can be rotated 180° and set
at either 45° or 90° angles.
TO ROTATE FENCE / CHANGE ANGLE SETTING
See Figure 6.
■ Unplug your detail biscuit joiner.
WARNING:
Failure to unplug your detail biscuit joiner could result in
accidental starting causing possible serious personal
injury.
■ Loosen the two height adjustment knobs.
■ Pull the fence forward and slide it down the front base until
it can be removed through the key hole slots.
■ Rotate the fence 180°.
■ Reinstall the fence on the front base. Place height adjust-
ment knob bolts in key hole slots and align bolt heads with
the slots on back of front base.
■ Slide fence up the front base to desired depth of cut.
■ Tighten height adjustment knobs securely.
See Figure 6.
Fig. 5
HEIGHT
SETTING SCALE
HEIGHT
ADJUSTMENT
KNOB(S)
Fig. 6
HEIGHT
ADJUSTMENT
KNOBS
FRONT
BASE
HEIGHT
ADJUSTMENT
KNOB BOLT(S)
FRONT
BASE
SLOT(S)
FENCE
KEY
HOLE
SLOTS
FENCE
(1) PULL
FORWARD
(2) SLIDE
DOWN
TABS
SLOTS
FENCE ORIENTATION
FOR 45° ANGLES
TO LOWER
FENCE