Filter
Top Products
15
ASSEMBLY
Fig. 9
Fig. 11
scraP
wood
chuck
hEad
assEmbLy
sPindLE
hEad
assEmbLy
INSTALLING CHUCK, HEAD ASSEMBLY, AND
FEED HANDLES
See Figures 9 - 11.
Place the head assembly upside down on a level, flat
surface.
Position chuck on spindle. Chuck should be fully opened
to avoid damaging jaws.
Using a piece of scrap wood to protect the chuck, firmly
tap the chuck into place using a mallet or hammer.
Position the head assembly onto the column with the
chuck positioned over the table.
NOTE: This tool is heavy. Get help when needed.
Slide the head assembly down as far as it will go. Align
the table assembly with the base and then tighten the
two head set screws with the hex key.
Attach the three feed handles by screwing them into the
threaded holes in the hub.
INSTALLING/CHANGING WORKLIGHT BULB
See Figure 12.
The integrated worklight can be used to help illuminate
the work area. The worklight requires a 15-watt, 120-volt,
candelabra-base bulb (bulb not included).
To install, insert the bulb into the worklight receptacle and
twist clockwise to secure.
sET
scrEws
fEEd
handLE
buLb
Fig. 10
Fig. 12