Filter
Top Products
10
ASSEMBLY
WARNING:
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and
possible serious injury.
ATTACHING THE COLUMN ASSEMBLY
See Figure 4.
■ Place base on a flat surface. Align screw holes in the column
support with screw holes in the base.
■ Place a hex bolt in each hole and tighten using an adjustable
wrench.
■ Loosen the set screw in the column support.
■ Set the column assembly in the base and secure in place
by tightening the set screw clockwise.
Fig. 5
0
0
10
20
30
40
10
20
30
40
TABLE
SUPPORT
TABLE LOCK
HANDLE
TABLE LOCK
HANDLE
TABLE
1
/
2
”
D
r
i
l
l
P
r
e
s
s
SET
SCREWS
1
2
D
r
l
l
i
P
r
e
s
s
O
N
FEED
HANDLE
HUB
Fig. 7
HOUSING KNOB
IDLER PULLEY
BELT
TENSION
SCREWS
BELT TENSION LEVER
Fig. 6
Fig. 8
ON
SPINDLE
SPINDLE
SHAFT
CHUCK
FEED
HANDLE
Fig. 4
HEX BOLT
TABLE
ADJUSTMENT
HANDLE
D-SHAFT
SET
SCREW
SET
SCREW
TABLE AND TABLE ADJUSTMENT HANDLE
ASSEMBLY
See Figures 4 and 5.
■ Slide the table adjustment handle onto the D-shaft aligning
the flat side of the shaft with the set screw. Secure the
table adjustment handle by tightening the set screw.
See
Figure 4.
■ Insert a table lock handle through the unthreaded hole
into the threaded hole at the rear of the table support.
Tighten by turning the table lock handle clockwise.
■ Insert a table lock handle through the unthreaded hole
into the threaded hole in the front of the table support.
■ Place the table in the table support. Tighten by turning
the table lock handle clockwise.
See Figure 5.
INSTALLING THE HEAD ASSEMBLY, FEED
HANDLES, AND HOUSING KNOB
See Figures 6 and 7.
■ Place the head assembly on the column and slide it as
far down the column as it will go. Tighten the two set
screws with the hex key provided.
■ Attach the three feed handles by screwing them into the
threaded holes in the hub. Tighten using a wrench on the
flats on the feed handles.
See Figure 6.
■ Unscrew the pan head screw from the housing knob.
Open the head assembly and fit the housing knob over
the hole on the outside and the screw in the hole from
the inside. Tighten into place.