Filter
Top Products
10
OPERATION
ROUGH SURFACE ADAPTOR
See Figure 7.
By using the rough surface adaptor, you can use the AIRgrip
feature to position the unit on many non-smooth surfaces,
including brick and painted cinder block.
NOTE: The AIRgrip feature cannot be used with stucco or
unpainted cinder block.
Place the adaptor over the AIRgrip base.
Place the unit against the desired surface and press
slightly to engage the seal.
Continue to hold the unit against the surface while press-
ing the on/off button.
Slowly release the unit when you hear a change in motor
sound.
CAUTION:
Before releasing the unit, make sure the unit is securely
adhered to the surface.
USING THE MULTI-FUNCTION BASE
See Figures 8 - 9.
Hook-and-loop strap and push pin methods are available
when the multi-function base is installed. To install, snap the
base over the AIRgrip vacuum seal.
HOOK-AND-LOOP STRAP: The strap can be used to attach
the laser level to irregularly shaped objects such as pipes,
boards, or metal grates.
Attach the strap to the multi-function base by threading it
through the loops. The looped (or fuzzy) side of the strap
should face the base.
Position the laser level against the surface where you
want it mounted.
Wrap the strap around the object being mounted (pipe,
board, etc.) and pass the end of the strap through the
retaining loop. Pull to tighten.
Place the hooked end of the strap against the looped (or
fuzzy) side of the strap and press together to secure.
NOTE: To use the hook-and-loop strap to hang the unit from
overhead, use the loops on top of the laser level housing.
PUSH PINS: Push pins allow the laser level to be mounted
to stucco and permeable surfaces.
Place the laser level on the surface where you want it
mounted.
Align push pin with angled hole located on one side of
laser level base and push in to secure.
In the angled hole on the other side of laser level base,
secure the second push pin.
Fig. 9
Fig. 8
Fig. 7