Filter
Top Products
9
OPERATION
Rotate the laser lens housing until the battery compart-
ment comes into view.
Remove battery cover plate.
Install two AA batteries according to polarity indicators
(+ or −) inside the battery compartment.
Reinstall the battery cover plate.
NOTE: Remove the batteries from both the vacuum base
and the laser if you will not be using the unit for an extended
time.
TURNING THE VACUUM BASE ON/OFF
See Figure 5.
Press the button located on the right side of the vacuum
base to turn it on and off. Always wait for at least 5 seconds
between stopping and restarting the unit.
USING THE AIRGRIP VACUUM
See Figure 5.
Vacuum grip technology allows the unit to be attached to
most smooth surfaces.
NOTE: The multi-function base is not used when mounting
by vacuum grip.
Place the unit on the surface you want it secured to and
press against the surface slightly to seal.
Continue to hold the unit against the surface while press-
ing the on/off button.
Slowly release the unit when you hear a change in motor
sound.
NOTE: Before releasing the unit, make sure the unit is
securely adhered to the surface.
NOTE: To release the vacuum seal, turn the power to the
vacuum base off. For fast release, press the vacuum release
button located on the left side of the unit. Pulling the unit
off the wall without releasing the vacuum could damage
the product.
To reposition the laser level while it is adhered to a sur-
face, depress the vacuum release button while allowing
the AIRgrip vacuum to continue running. This will release
the seal enough to allow you to slide the unit to a different
position.
TURNING THE LASER ON/OFF
See Figure 6.
Depressing the on/off button located on the top of the laser
level cycles the laser through three different operational
modes.
Depress the button once to turn on a horizontal laser
line.
Depress the button again to switch to a vertical line.
Depress the button a third time to switch to the crosshair
laser line.
Turn the laser off by depressing the button a fourth
time.
Fig. 4
Fig. 5
Fig. 6
LASER ON/OFF
BUTTON
LINE HEIGHT
ADJUSTMENT
KNOB
LASER LENS
HOUSING
BATTERy
COVER PLATE
ROTATIONAL
ADJUSTMENT
KNOB
AIRGRIP
VACUUM
ON/OFF
BUTTON
VACUUM
RELEASE
BUTTON