15
ANGLE CUTTING (BEVEL CUTTING)
See Figures 12 and 13.
Bevel cutting angles may be adjusted from 0° to 45° right
or left. Angles for cuts from 0° to 45° in 15° increments are
marked on a scale on both the left and right side of the base.
An arrow under the motor assembly provides an indicator at
each of the above mentioned 15° increments. A protractor is
recommended when accurate cuts are required.
n Unlock the base by moving the base locking lever for-
ward.
n Align the mark, on the base, of the desired angle with the
indication arrow located on the housing.
n Once the desired angle is reached, tighten the base lock-
ing lever by moving the base locking lever under the motor
assembly.
BASE
LOCKING
LEVER
OPERATION
Fig. 12
Fig. 13