Filter
Top Products
21
�
�
OPERATION
red LED does not come on after 30 minutes, this may
indicate a defective battery pack and should be
replaced.
n After normal usage, a minimum of 1 hour of charging time
is required to fully recharge battery pack.
n The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
n Do not place the charger and battery pack in an area of
extreme heat or cold. They will work best at normal room
temperature.
NOTE: The charger and battery pack should be placed
in a location where the temperature is more than 50°F
but less than 100°F.
n When batteries become fully charged, unplug the
charger from power supply and remove the battery
pack.
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down for approximately 30 minutes before attempting to
recharge. When the battery pack becomes discharged and
is hot, this will cause the green LED to come on instead of
the red LED. After 30 minutes, reinsert the battery pack in
the charger. If the green LED continues to remain on, return
battery pack to your nearest Ryobi Authorized Service Center
for checking or replacing.
NOTE: This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to “CHARGING
A COOL BATTERY PACK” for normal recharging of batter-
ies. If the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Ryobi Authorized Service Center
for electrical check.
After all parts have been assembled properly, the battery
pack can now be attached to tool.
TO INSTALL BATTERY PACK
See Figure 31.
n Place battery pack in the saw. Align raised rib on battery
pack with groove inside saw.
�n Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
CAUTION:
When placing battery pack in the saw, be sure raised rib
on battery pack aligns with groove inside saw and latches
snap into place properly. Improper assembly of battery
pack can cause damage to internal components.
Fig. 31
BATTERY
PACK
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 29
CHARGER
YELLOW LED
RED LED
Fig. 30
CHARGER
BATTERY
PACK
GREEN LED
BATTERY PACK SHOWN ATTACHED TO CHARGER
TO REMOVE BATTERY PACK
See Figure 31.
n Locate latches on each side of the battery pack. Depress
the latches to release the battery pack from the tool.
�n Remove the battery pack from the tool.