Ryobi S606D Sander User Manual


 
Page 6
ELECTRICAL CONNECTION
Your sander has a precision built electric motor. It should be
connected to a power supply that is 120 volts, 60 Hz, AC
only (normal household current). Do not operate this tool
on direct current (DC). A substantial voltage drop will cause
a loss of power, and the motor will overheat. If your tool does
not operate when plugged into an outlet, double-check the
power supply.
WARNING: Do not allow familiarity with your sander to make you careless. Remember, a careless fraction
of a second is sufficient to inflict severe injury.
PAPER PUNCH
Fig. 1
TAB
LEVER
CUSHION
SWITCH
ON
OFF
SWITCH
PAPER CLAMP
PLATEN
DUST BAG
FEATURES
Your sander is suitable for sanding with coarse, medium, and
fine grit sandpaper. It will produce a fine scratch free finish
when used to sand with the grain on wood surfaces. It has
been designed so that flush corner sanding on three sides of
the sander is possible.
Your sander has a comfortable palm grip handle that provides
maximum one-hand comfort, and reduces operator fatigue
during continuous sanding operations.
Your sander has quick action paper clamps. This makes
changing or replacing sandpaper fast and easy.
Your sander also has a built in dust collection that collects
dust through punched holes in the sandpaper and cushion.
See Figure 1.
Before attempting to use your sander, familiarize yourself
with all operating features and safety requirements.
SWITCH
This tool is equipped with a simple switch control. To turn
your sander "ON", depress the switch button as shown in
Figure 1. Depress the switch button in the opposite direction
to turn your sander "OFF".