Ryobi Outdoor BGH826 Grinder User Manual


 
Page 7
LOOSE PARTS LIST
LOOSE PARTS LIST
The following items are included with your Bench Grinder:
Shield Rods – one left, one right ................................ 2
Shield Rod Brackets with Hardware ........................... 2
Safety Shields ............................................................. 2
Spark Deflectors .........................................................2
Work Rests – one left, one right ................................. 2
Lock Washers (5 mm) ................................................. 2
ADJUSTABLE WRENCH
Fig. 2
TOOLS NEEDED
The following tools (not included) are needed for assembly and alignment:
7 mm, 10 mm, and 12 mm
COMBINATION WRENCH
PHILLIPS SCREWDRIVER
Carefully remove all parts from the shipping carton.
Lift the bench grinder from the carton and place it on a
level work surface.
Do not discard the packing materials until you have care-
fully inspected the machine, identified all loose parts, and
satisfactorily operated your bench grinder.
Examine all parts to make sure no breakage or damage
has occurred during shipping.
If all parts have been included, proceed to assembly.
If any parts are damaged or missing, do not attempt to
UNPACKING
plug in this tool or turn it on until the damaged or missing
parts are obtained and installed correctly.
Contact your nearest Ryobi dealer or call 1-800-525-2579
in the United States or 1-800-265-6778 in Canada for
assistance if any parts are missing or damaged.
WARNING:
If any parts are missing do not operate this machine until
the missing parts are replaced. Failure to do so could
result in possible serious injury.
Washers (5 mm).......................................................... 2
Washers (8 mm).......................................................... 2
Phillips Screws (5 mm x 8) ......................................... 2
Hex Bolts (8 mm x 14) ................................................ 2
Hex Bolts (5 mm x 10) ................................................ 2
Operator's Manual