Filter
Top Products
2 C4600M (3/09)
About This Guide
Thank you for purchasing Pelco’s Endura
®
workstation with WS5000 advanced system software version 2.0. This guide provides basic
instructions on how to connect your Endura workstation, start the software, monitor live video, and work with recorded video.
For detailed instructions on installing, programming, and using your Endura workstation, refer to the installation and operation manuals included
with your unit.
Connecting the Equipment
Refer to Figure 1 as you make the front and back panel connections required to operate this unit:
1. Connect video output (DVI). To connect a VGA monitor to this output, use a DVI-to-VGA adapter plug supplied with the Endura workstation.
2. Connect the audio input and output.
3. Connect Cat5e or better network cable to the 1 gigabit RJ-45 network port and to the Endura network.
4. Connect the keyboard and mouse to USB ports (front or back panel).
5. Connect the power cable to the power connector and a power source. Turn on the power switch.
6. Turn on power.
7. Check the Network Activity indicator.
8. Check the Unit Status indicator.
Figure 1. Connecting the Endura Workstation
POWER INDICATOR
03267-39-0020
SN
PRODUCT SERIAL STICKERNUMBER
DVD/CD
DRIVE
NETWORK
ACTIVITY
UNIT STATUS
CONFIGURATION/
RESET BUTTON
USB 2.0 PORT
POWER BUTTON
AUDIO OUT
MICROPHONE IN
AUDIO IN
POWER CONNECTOR
WITH ON/OFF SWITCH
DIGITAL VIDEO (DVI)
CONNECTORS
NETWORK
CONNECTOR (RJ-45)
USB 2.0 PORTS