Schumacher PID-750 Welding System User Manual


  Open as PDF
of 28
 
3
• OnlyconnectthePower Inverter to a 12-Volt battery. Make
sure the AC plug connection is tight.
• DonotmodifytheACreceptacleinanyway.
• Useonly45-ampfuses.
• ThisdevicedoesnotincludeaninternalGroundFault
Circuit Interrupter (GFCI).For GFCI protection, use a
ColemanCable02822GFCIoutlet.
WARNING: Handling the cord on this product or cords as-
sociated with accessories sold with this product, may expose
you to lead, a chemical known to the State of California to
cause cancer and birth defects or other reproductive harm.
Wash hands after handling.
BEFORE USING PID-750 POWER INVERTER
It is important to know the continuous wattage of the
device you plan to use with the inverter. The PID-750 must
be used with devices drawing 750 watts or less. If the
wattage is not marked on the device, an estimate can be
madebymultiplyingtheACinputcurrent(Amps)bytheAC
voltage(110V).
Devices like TVs, fans or electric motors require additional
power to start (commonly known as the “starting or peak
power”). The PID-750 can supply a momentary surge
in wattage; however even devices rated less than the
maximum 750 watts can exceed the inverters surge capa-
bility and cause an automatic overload shutdown.
 previous next