Schumacher PID-750 Welding System User Manual


  Open as PDF
of 28
 
4
Make sure the device you are using is compatible with a
modiedsinewaveinverter.
OPERATING INSTRUCTIONS
Connecting to a 12 Volt Battery:
The PID-750 battery clamps allow quick hook-up to a
12Vbattery.MakesurethePID-750andthedevice(s)are
turned OFF.
1. Unscrewthepositive(red)andnegative(black)plastic
connector knobs from the back of the inverter.
2. Sliptheendofthered(positive)batterycableclamp
wireoverthered(positive)threadedextensionandthen
screw on the connector knob and tighten so the wire is
firmly attached. Repeat the same process for the black
wire.
3. Connectthered(positive)batterycabletothepositive
(+)batteryterminaltakingcaretoshieldeyes,clothing
and hands from battery acid. Connect the black battery
clamptonegative(-)groundonthebattery.
4. Plug the device into the Power Inverter 750 AC outlet.
NOTE: If using more than one device, the total combined
wattage of both devices must not exceed 750 watts.
5. ToturntheinverterON(I)orOFF(0),pressandhold
buttonfor2seconds.TurntheinverterON.
 previous next