Filter
Top Products
6
553
Wheel Charger Assembly Instructions:
NOTE: Charger must be assembled before operating
Parts
(2) 10-32 thread cutting screws
(2) 1/4-20 thread cutting screws
(2) wheels
(2) axle caps
(2) axle brackets
(1) handle
(1) mounting foot
L. ASSEMBLY INSTRUCTIONS
Tools necessary
5/16" wrench
3/8" wrench
Hammer
Screwdriver
Hubs must face in FIG. A; Axle bracket FIG. D & B.; Axle cap FIG. E.
First place the charger topside down on a flat surface.
Next mount the mounting foot FIG. A with (2) 1/4-20 screws.
Next pound the axle firmly into an axle cap using a hammer FIG. B.
Next slide the wheels onto the axle, hubs must face in, FIG. C.
Next pound the other axle cap onto the other end of the axle.
Next place the axle assembly onto the bottom of the charger as shown in FIG. C.
Mount the axle to the bottom of the charger using (2) 10-32 thread cutting screws as shown in FIG. D.
(these screws require a 5/16" wrench).
Next turn the battery charger right side up onto its foot and wheels.
Remove the (2) top screws from each side of the charger, line up the handle and reinstall the screws FIG. E.
Fig. E
AXLE CAP
Fig. B
Fig. D
AXLE BRACKET
Fig. A
HUBS MUST
FACE IN