Filter
Top Products
Assembly (continued)
Assembling Dust Elbow
1 Locate the dust elbow
2 Unplug power cord.
3 With the miter arm locked in the down position,start
the dust elbow onto the dust nozzle at an angle to
retaining lip. SECOND
4. Firmly press the dust elbow the rest of the way onto RETAINING
the second retaining lip LIP
NOTE: At first time installation, or if assembled in a cool
or cold climate, the rubber is not as flexibleand will be
more difficult to assemble.
Alignment .........
Step One-Checking and Adjusting Blade
Squareness to Fence (Miter Alignment)
,, i,i ,,,,i,,
DUST ELBOW
WARNING: To avoid injury from unexpected
starting or electrical shock, do not plug the saw
in. The power cord must remain unplugged
whenever you are working on the saw.
1 To check blade squareness to fence, use a combi-
nation square, Place the square against the fence
and next to the blade as illustrated. Place the square
so the set in the teeth won't hold it from the blade
The blade should contact the full length of the
square
2. If blade contacts fult length of square, proceed to
next adjustment, tf blade is not square to the fence,
follow the alignment procedures: a through f.
a Loosen miter lock knob a haft turn. The saw
power head should still be secured in the lowered
positionby the stop shaft_
NOTE: Take the saw off its stand, bench or ply-
wood base if readjustment is necessary.
I CAUTION: To keep from losing control of the
unit, steady the base with one hand while Ioos-
]
ening the two bolts with the other hand.
b With the unit securely resting on a large stable
surface, tilt the unit by lifting up on one side or the
other of the base. Using allen wrench supplied,
loosen the two miter index spring cap head
screws on the underside of the turn table.
Co Return the saw to its normal resting position
Make sure the miter lockknob is loose but do not
release the indexspring.
d. Use the miter saw knob to move the turn table
and saw so that the blade contacts the full length
of the square. Watch out for tooth seL Turn the
miter lock knob clockwise to lock saw square to
fence
e Tilt saw as in Step b and tighten cap head
screws
f Recheck blade squareness to fence and readjust
if necessary.
MITER INDEX SPRING
CAP HEAD SCREWS
\
10