Filter
Top Products
Assembly ......................................................................
Removing or Installing the Blade
WARNING: To avoid injury from a thrown work-
piece or thrown pieces of blade, do not use a
blade larger or smaller than 10" diameter.
WARNING: To avoid injury from unexpected
starting, unplug the saw whenever you are
removing or installing the blade.
1. Unplug the saw from the outlet
2 Loosen the cover plate stop screw with phillips end
of the combination wrench, supplied.
3 Lift the lower guard up and tilt the lower guard
assembly back so the arbor screw is exposed.
4a. For Model 113 235220 & 113 235240 only, find the
arbor lock between the upper guard and the miter
saw handle press the arbor lock and hold it in firmly
while turning the arbor screw The arbor lock will
engage within one revolution
4b For either saw model you may lower the blade
down on to a scrap piece of wood positioned
against the fence This will serve as an alternate
locking means
5. Place the 1/4" allen end of combination wrench
supplied into the arbor screw. Remove the arbor
screw, outer blade collar, and the blade
NOTE: Pay attention to pieces removed, noting their
position and direction they face (see illustration)Wipe
the blade collars clean of any sawdust before installing
a new blade
6. Install the new 10" blade (see recommended
accessory list) Make sure the rotation arrow on the
blade matches the clockwise rotation arrow on the
upper guard.
7 InstaLlthe outer blade collar, and arbor screw Turn
the alien wrench counter clockwise to secure the
blade Tighten arbor screw securely,
8. Lower the lower blade guard until the slot in cover
plate rests all the way down on the coverptate stop
screw. Tighten the screw with phillips end of the
combination wrench, supplied.
DANGER: Never use saw without cover plate
securely in place. It keeps the arbor screw from
falling out if it accidentally loosens, and pre-
vents the spinning blade from coming off the
machine.
9 Be sure the arbor lock is released so the blade
turns freely
NOTE: On Model 113235220 & 113235240, the arbor
lock can be damaged by improper use
MITER SAW
HANDLE
COVER PLATE
ARBOR COVER PLATE
SCREW STOP SCREW
ARBOR
LOCK
LEFTHANDTHREAD
UPPER
BLADE
GUARD
BLADE
"COLLARS
BLADE COLLARS
BLADE
:ESSES
WARNING: Make sure the collars are clean and
properly arranged. After installing a new blade,
make sure the blade clears the table slot at the
0° and 45 ° bevel positions. Lower the blade
into the lower table and check for any contact
with the base or turn table structure.
\
ARBOR
SCREW
BLADE