Filter
Top Products
SWITCH
FROM POWER
OR LUBRI-
An occasional coat of paste wax on the work table will:allow
the wood being CuttOglide smoothly across the work surface.
MOTOR
if the powercord is worn, cut, o_ damaged in any way, have
it replaced immediately.
Do not attempt to oil the motor bearings or service the motor
internal parts.
ARM BEARINGS
Lubricate the arm bearings after 10 hours of use. Re-oil after
every 50 hours of use or whenever there is a squeak coming
from the bearings. Four plastic bearing caps are provided with
this saw. Add SAE20 oil into each cap and then snap cap onto
arm bearing. Leave caps on bearings for overnight and then
remove an_ store caps for later use.
ALTERNATE METHOD OF OILING BEARINGS IF
RE,OIL CAPS ARE LOST.
I. Turn saw on its side.
2. Squirt a generous amount of SAE 20 oil around the shaft
end and bronze bearing.
3. Let the oil soak in overnight in this condition.
4, Next day repeat the above procedure for the opposite side
of the saw.
BLADE GUARD REMOVED
FOR PICTURE CLARITY