Filter
Top Products
getting to know your band saw/sander
9. GUIDE BAR
When the upper guides are raised or lowered, they must
not deflect the blade sideways. This means th at the guide
bar must be parallel to the blade, or square with the
table.
1. Remove the blade guard, cover, blade, and the upper
guide assembly.
2. Lower the guide bar until the end =sapproximately
1-3/4" from the table.
3. Hold a square on the table against the guide bar
4. If the bar s not square with the table, lock the guide
bar and oosen the four screws in the guide bar
support witl_ a 3/16" setscrew wrench To reach the
lower left screw, it wil be necessary to tilt the upper
wheel ouTwara.
NOTE: 'The holes in the guide bar support are larger
than the screws. This allows the support to be moved.
5. Move the guide bar until it is square with the table,
then tighten the screws.
6. Be sure to replace the blade guard before operation.
SCREW
(4 Total}
/
_//3/16'" SETSCREW
WRENCH
BAR
COMBINATION
SQUARE
INSTALLING SANDING ATTACHMENT
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND ALWAYS REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE INSTALLING SANDING
ATTACHMENT.
1. Remove the blade guard, the table insert, and the table
alignment screw.
2. Remove the cover release the blade tension and remove
the blade.
3, Remove the upper blade guide assembly. Use a 7/16"
wrench to remove the screw.
4. Loosen the setscrew that locks the lower thrust bearing,
ano move the bearing as far back as it will go. Retighten
setscrew
5. Loosen the two setscrews that lock the lower blade
guides. Spread them apart so that the end of each guide
is inside the holder. Retighten setscrew.
,/ /'
K(O/)I .UPPERBLADEGUIDE
HEX. HD. SCREW
ASSEMBLY
18