Sears 315.10924 Saw User Manual


 
OPERATION
TO POCKET CUT (Cont'd.)
After you complete your cut release the trigger and
allow the blade to come to a complete stop. DO NOT
REMOVE YOUR SAW FROM WORKPIECE WHILE
THE BLADE IS MOVING.
Corners may then be cleaned out with a hand saw or
sabre saw.
TO BEVEL CUT
The angle of cut of your saw may be adjusted to any
desired setting between zero and 45 degrees. There
is a notch in the saw base to help you line up the
blade with the line of cut. See Figure 15. Align your
line of cut with the inner edge of the notch in the saw
base when making full 45 degree bevel cuts. Since
the thickness of blades vary and different angles re-
quire different settings, always make a trial cut in
scrap material along a guideline to determine how
much you should offset the guideline on the board to
be cut.
When making a bevel cut hold your saw firmly with
both hands as shown in Figure 16. Rest the front
edge of the base on the work. Push in the lock-off
button and squeeze the switch trigger. ALWAYS LET
THE BLADE REACH FULL SPEED, THEN GUIDE
YOUR SAW INTO THE WORK.
After you complete your cut release the trigger and
allow the blade to come to a complete stop. DO NOT
REMOVE YOUR SAW FROM WORKPIECE WHILE
THE BLADE IS MOVING.
TO ADJUST BEVEL SETTING
1. UNPLUG YOUR SAW.
2. Loosen wing nut. See Figure 15.
3. Raise motor housing end of saw until you reach
the desired angle setting on bevel scale. See
Figure 15.
4. Tighten wing nut securely.
WING
TOP VIEW
OF SAW
MOTOR
ISING
BEVEL SCALE
NOTC[ IN _
SAW BASE
GUIDELINE
ALIGN INNER EDGE OF NOTCH IN SAW
BASE WITH LINE OF CUT AS SHOWN
WHEN MAKING 45 ° BEVEL CUTS
Fig. 15
LOWER BLADE
GUARD
,.,.Fig. 16
Page 11