Sears 315.10924 Saw User Manual


 
MAINTENANUI=
WHEN SERVICING USE ONLY IDENTICAL REPL'/_CEMENT PARTS
POWER CORD OR SWITCH REPLACEMENT
1. UNPLUG YOUR SAW.
2. Remove screws and wing nut securing handle
cover. See Figure 17.
3. Carefully lift handle cover away from tool.
4. Note the locations of all lead wiring inside the
handle and how each connection has been made.
IMPORTANT: When the new cord or switch is in-
stalled, identical connections must be made.
5. Remove the lead wires from the switch by insert-
ing a 1/32" diameter pin or nail into each switch
lead receptacle and pull the lead wires as shown
in Figure 16. This will release the wires. Remove
the pin or nail with a twisting motion.
6. To replace lead wires, push each lead wire into its
proper receptacle. NOTE: Be sure to push lead
wires into switch as far as possible.
7. Locate the switch in the handle and place all wir-
ing so it cannot be pinched or contact screws
when handle cover is replaced.
8. Replace handle cover, screws, and wing nut.
9. Tighten screws and wing nut securely.
HANDLE
COVER
SCREWS
WING NUT /
SCREW
1/32" DIAMETER
NAIL OR PIN
Fig. 17
GENERAL
Only the parts shown on parts list, page 15, are in-
tended to be repaired or replaced by the customer.
All other parts represent an important part of the
double insulation system and should be serviced on-
ly by a qualified s_rvice technician.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, carbon dust,
etc.
When electric tools are used on fiberglass boat
sports cars, etc., it has been found that they are sut
ject to accelerated wear and possible prematut
failure, as the fiberglass chips and grindings a_
highly abrasive to bearings, brushes, commutato
etc. Consequently it is not recommended that th
tool be used for extended work on any fibergla_
material. During any use on fiberglass it is extremel
important that the tool is cleaned frequently by blov
ing with an air jet. ALWAYS WEAR SAFET
GLASSES, DUST MASK, OR EYESHIELDS BEFOR
BEGINNING POWER TOOL OPERATION OR BLOV
ING DUST.
THE FOLLOWING RECOMMENDED ACCESSORIES WERE AVAILABLE AT THE TIME THIS MANUA
WAS PRINTED.
Cord Lock _ 2595)
Carrying Case (914702)
Rip Guide (9_27679)
50' 14 A.W.G. Ext. Cord (9 5821)
71/4 Saw Blade _ 32303)
71/4 Saw Blade _ 32423)
71/4 Saw Blade _ 32494)
71/4 Saw Blade _ 32564)
100' 14 A.W.G. Ext. Cord (9 83508)
71/4 Saw Blade _ 32664)
71/4 Saw Blade _ 32444)
71/4Saw Blade _ 32526)
71/4Saw Blade (932518)
7l/;_Saw Blade _ 32489)
_The use of attachments or accessories not listed above might be hazardous.
Page 12