Filter
Top Products
6
FIGURE 7
• Assemble the large and small spray gun clips to the
side of the tank using two #10 x 1/2" screws and #10
lock washers. See gure 7.
• Slide a 3/8" hose clamp onto the boom connecting
hose. Place the end of the hose through the conduit
clamp (attached to the pump) and then slide a second
3/8" hose clamp onto the hose. Leave hose clamps
loose for now. See Figure 8.
• Push the hose onto the hose adapter in the end of
the "On-Off" valve. Tighten the hose clamp around the
hose and adapter. See gure 8.
• Position the valve and hose clamp up against the
conduit clamp. Slide the other hose clamp against the
other side of the conduit clamp. Tighten the clamp
without collapsing the hose. See gure 8.
• Slide the coiled hose clamp onto the spray gun hose
and then push the hose onto the hose adapter on the
1/4" tee tting. Tighten the hose clamp around the
hose and adapter. See gure 8.
• Snap the spray gun into the clips on the front of the
tank. (The large clip holds the spray gun handle and
the small clip holds the wand.) Refer to gure 7.
FIGURE 10
FIGURE 8 VIEWED FROM FRONT
DANGER! Never allow negative pin on
plug to come in contact with positive
"hot" post on battery. Fire or explosion
may result!
FIGURE 9
IMPORTANT: This sprayer should be connected to 12
volt batteries only!
• To connect the wire harness to the tractor, attach the
red wire to the positive post on the battery or to the
"HOT" connection on a tractor switch or ammeter.
The brown wire may be grounded or connected to the
negative battery post. See gures 9 and 10.
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
#10 x 1/2"
SCREW
#10 LOCK
WASHER
COILED HOSE CLAMP
CONDUIT
CLAMP
1/4" TEE
ON - OFF
VALVE
SPRAY GUN
HOSE
BOOM
CONNECTING
HOSE
3/8" HOSE CLAMPS
BROWN
PUMP SWITCH
RED
QUICK COUPLER
BATTERY
+
RED
BROWN
PLUG
NEGATIVE PIN
12 VOLT TRACTOR BATTERY
POSITIVE
"HOT"
POST
+
NEGATIVE
POST