Filter
Top Products
9
Using the engine start feature
The Engine Start is a feature to help start the engine
of your vehicle:
1. Push the switch located on the front panel to
CHARGE/TEST.
2. Push SELECT BUTTON and choose 125A
START (6 volt) or 225A START (12 volt). The
ENGINE START feature will deliver 125 amps to
help crank a 6-volt system and 225 amps to help
crank a 12-volt system.
3. Push the symbol located in the Timer Set Time
section until the number 5 is displayed.
4. Crank the engine for no more than 5 seconds. If
it does not start, wait three minutes before
cranking again for no more than 5 seconds.
NOTE: During extremely cold weather, or if the
battery is severely exhausted, charge the battery
for about 5 minutes in the 50 amp setting before
cranking the engine.
Using the compressor
4. The air compressor will run for a maximum of 15
minutes or it may automatically shut down sooner
if a high load causes it to overheat. It will then cool
for 20 minutes. The digital display will read HOT.
After 20 minutes, the air compressor will automati-
cally restart.
5. If HOT reads on the digital display when first using
the compressor, leave the charger on for one
minute and the compressor will restart.
6. To turn off the air compressor, push the switch
located on the front panel to OFF.
ESTIMATED TIME FOR INFLATING
Car Tire P205/75R14 1 - 8 minutes
Truck Tire 265/75R16 2 - 15 minutes
Bike Tire 26 x 1.95 In. 30 seconds to 2 minutes
Read the LED display to ensure proper pressure has
been reached. Do not over inflate.
5. After the engine starts, push the switch located on
the front panel to OFF. Unplug the charger power
cord from the wall outlet.
6. Disconnect the output clamps from the battery.
7. Clean and store the charger in a dry location.
IMPORTANT: Do not try to start the engine without a
battery in it. You could cause damage to the electrical
system.
If the engine does turn over, but never starts, there is
not a problem with the starting system. There is a
problem somewhere else with the vehicle. STOP
cranking the engine until the other problem has been
diagnosed and corrected.
CAUTION – Read instructions of the product being
inflated before using the compressor. Avoid over
inflation, do not exceed the manufacturer’s recom-
mended pressures. Do not leave the air compressor
unattended during use.
NOTE: The 12 volt compressor is rated for 120 PSI.
The compressor will not start at pressure greater than
80 PSI.
To use the air compressor:
1. If necessary, unscrew the valve stem cap from the
tire.
2. Attach the brass nozzle of the compressor hose
and thread onto the tire stem until it is secure.
3. To start the air compressor, push the switch
located on the front panel to AIR COMPRESSOR.
The Air Pressure/PSI LED will light and the PSI
will show in the digital display.
3-WAY
SWITCH
DIGITAL
DISPLAY