Woodstock D2677 Cordless Drill User Manual


  Open as PDF
of 44
 
-10-
Installing rack and table bracket.
Alignsetscrewwithflatpadon
pinion.

TheW1669comeswithaonegearedtable
bracket.TheW1670comeswithagearedtable
bracket and table support arm, which allows
the distance between the column and table to
beadjusted.Notablesupportpartsareinter-
changeable between the two drill presses.



Insert the table lock lever through the un-
threadedhole(see
)inthe
table
bracket, and then tighten the lever into
the threaded side exactly three turns.

tarting with the pinion gear, insert the
shaft into the table bracket and mesh the
teeth with the worm gear as shown in


Alignthesetscrewinthecrankhandle
with the flat pad on pinion shaft.

Tighten the 3mm set screw to lock the
handleinplace(see
).

Examine the rack and note that the rack
teeth at one end are cut closer to the end
of the rack than the other.

Insert the rack through the table bracket
so the end that has the rack teeth cut clos-
ertotheendispointingdown(see
).

Hold the rack against the worm gear and
slide the table bracket and rack onto the
column(see

).
Pinion and worm gear installation.
Pinion
Gear
Worm
Gear
Un-threaded Hole
Flat
Pad
Set Screw

 previous next