Woodstock D2677 Cordless Drill User Manual


  Open as PDF
of 44
 
 Alwaysoperateyourdrillpressatspeedsthatareappropriateforthedrill
bitsizeandthematerialthatyouaredrilling.
  Feed the drill bit evenly into the workpiece. Back the bit out of deep holes and
clear the chips with a brush after you have turned the machine off.
  Use only round, hex or triangular shank drill bits, and make sure
the drill bit you are using is tightened properly..
  Never do maintenance or change speeds with this machine plugged in.
  Never use tools that are in poor condition. Cutting tools that are dull
ordamagedaredifficulttocontrolandmaycauseseriousinjury.
  Never hold a workpiece by hand while drilling, never drill sheet metal
unless it is clamped securely to the table, and always secure the workpiece to the table before
drilling.
  Properly position workpieces to avoid drilling into the table.
 Afaceguardusedorsafetygogglesisrecommended.
  Habits – good and bad – are hard to break. Develop good habits in your shop and
safety will become second-nature to you.
-
5-
 Themachinewilldoasaferandbetterjobattherateforwhichitwas
designed.
 forcemachineorattachmenttodoajobforwhichitwasnotdesigned.
 wearlooseclothing,neckties,gloves,jewelry;andtiebackhair.
 Before turning the machine on, make it a habit to check that
alladjustingkeysandwrencheshavebeenremoved.
 Whenusinganextensioncord,makesureitisingoodcondition.
Whenextensioncordis100feetandlessinlength,usethosethatareratedStandardService
(gradeS)orbetter,andthathaveaconductorsizeof16AWG.Adropinlinevoltage,lossof
powerandoverheatingcanresultwhenusinganundersizedcord.Theextensioncordshouldhavea
ground wire and ground plug pin, as well.
  at all times.
 Waituntilitcomestoacompletestopbeforeleavingthearea.
 Follow lubrication and accessory attachment instruc-
tions in the manual.
 Operatingmachinesnearpilotlightsand/oropenflames
creates a high risk if dust is dispersed in the area. Dust particles and an ignition source may cause
an explosion.  operate the machine in high risk areas, including but not limited to, those
mentioned above.


 previous next