Filter
Top Products
-5-
Model W1702 Manual Insert (Mfg. Since 8/10)
The Model W1702 is capable of operating in two
directions by use of a forward/reverse switch
as shown in It is very important that
the workpiece be fed against the direction of
the cutter rotation. This will prevent a climb
cut and maintains a safe cutting procedure for
the operator. There will be times when it is
necessary to flip the shaper cutter over and run
it in the opposite direction, and feed the board
from the opposite end of the shaper.
When the switch is pointing to the
position, the spindle and cutter rotate
counter-clockwise.
When pointing to the position, the
spindle and cutter rotate clockwise.
When the forward and reverse switch is
pointing to the position, the shaper
motor has no power, but power is still
going to the switch.
the
power cord from the shaper to the power
source before changing cutters or doing an
adjustment or maintenance.
Always try to operate the shaper so the wood
is cut from the underside. Topside cutting is
more dangerous for the operator, because when
the wood is cut on the top side, the cutter can
lift and grab the wood and cause severe injury!
Refer to on , for specific
recommendations.
Forward/reverse switch.
Replaces Page 23
The forward/reverse switch comes with a
padlock so that the switch can be disabled when
the machine is not in use. This will ensure that
only authorized operators can use the shaper.
NOTICE
12.5 Radius
5
10
30
16
24
Dimensions Expressed in Millimeters