Filter
Top Products
Tool rest installed on lathe bed.
Before installing a tool rest, decide which
one will be best for your application. Unless
workpiece clearance is an issue, install the
larger tool rest to give yourself more room to
work.
Insert the tool rest into the tool holder as
shown in .
Lock the tool rest in place with the tool rest
lock.
-14-
Tightening face plate to
headstock spindle.
The face plate can be installed only if the spur
center has been removed from the headstock
spindle.
Thread the face plate onto the headstock
spindle.
. Tighten the face plate by placing a wrench
on the spindle flats and inserting the knock-
out tool into the spindle shoulder to hold
it in position during tightening. See
.
Reverse steps 2-3 to remove the face
plate.
Tool Rest
Lock