Filter
Top Products
-21-
Typical spindle sanding operation.
Lock nut that secures the tool
holder to the bed (lathe turned upside-down
for clarity).
Removing tool rest.
After turning, the workpiece can be sanded
(see example in ) and finished before
removing it from the lathe.
Whenever sanding or finishing on the Model
W1704, remove the tool rest holder to increase
personal safety and gain adequate working
room.
Remove the tool rest from the holder, as
shown in .
Using a 12mm socket or wrench, remove the
lock nut ( ) that is located under
the tool rest holder on the bottom side of
the bed.
Pull the tool rest holder off the bed and
replace the lock nut on the threads, so that
it does not get lost.