Filter
Top Products
-13-
W1758 Owner's Manual (Mfg. Since 3/10)
Using the 6mm hex wrench, secure the lathe to the
legs with the eight cap screws and lock washers, as
shown in .
Install the handle into the tool rest, as shown in
.
Align the quill keyway with the entry hole of the
quill lock lever (see , then install the
lever into the tailstock so that the end of it mates
with the quill keyway.
Make sure the dog-end of the lock lever fits
into the quill keyway so that the quill can move in
and out of the tailstock without rotating.
Securing lathe to legs.
Installing tool rest handle.
Digital readout installed onto
the headstock (viewed from the back).
Secure the digital readout to the top of the head-
stock, as shown in .
Quill locking lever installed.
Quill
Keyway
Quill Locking
Lever