Filter
Top Products
-26-
W1808/W1809/W1810 Cyclone Dust Collectors
SET UP
27. Place the lid on the collection drum and hook the
latches over the lid, as shown in
Figure 35, and
clamp in place.
28. Move the collector drum under the dust collector
and connect it to the cyclone funnel with clear 9"
flexible hose and the two 9" hose clamps, as shown
in Figure 36.
29. Model W1810 Only: Slide the reducer over the port
on the barrel (
Figure 37), line up the mounting
holes, and secure it in place with the (3) M4 x 12 tap
screws.
Figure 35. Latch hooked over lid for
clamping.
Figure 36. Drum attached to cyclone
funnel with 9" hose clamps.
Figure 37. Reducer installed (Model
W1810).
30. Mount the switch on the stand, as shown in Figure
38, with (2)
3
/8"-16 x
3
/4" hex bolts, (4)
3
/8" flat
washers, and (2)
3
/8"-16 hex nuts.
Figure 38. Switch mounted to stand.