Filter
Top Products
-11-
Model W1815 (Mfg. Since 10/10)
SETUP
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped with the Model W1815. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Main Inventory (Figure 3) Qty
A. Sander Assembly ...........................................1
B. Left Side Panel ............................................1
C. Right Side Panel ...........................................1
D. Upper Shelf 16
3
⁄4" x 15
3
⁄8" ..............................1
E. Lower Shelf 16" x 18
3
⁄8" ..................................1
F. Rear Panel ..................................................1
G. Panel and Door Assembly .................................1
H. Miter Gauge Assembly ....................................1
I. Wrench 10 x 13 ............................................1
J. Bolt Bag .....................................................1
—Flat Washers
5
⁄16" ........................................4
—Hex Bolts M8-1.25 x 45 .................................4
—Hex Nuts
3
⁄8"-16 .........................................4
—Feet ........................................................4
—Flange Bolts M6-1 x 12 ..................................8
—Carriage Bolts
5
⁄16"-18 x
3
⁄4" ...........................8
—Flange Nuts
5
⁄16"-18 .....................................8
Inventory
A
J
I
H
B
C
D
E
F
G
Figure 3. Inventory.
Keep machine disconnected from
power until instructed otherwise.
Immediately discard all plastic bags
and packing materials to eliminate a
choking and suffocation hazard for
children and animals.