Filter
Top Products
-22-
Model W1815 (Mfg. Since 10/10)
SERVICE
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
tech-support@shopfox.biz.
General
MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
Table Gap & Parallelism
The miter slot must be parallel with the face of the
sanding disc and there should be a
3
⁄16" gap between the
edge of the table and sanding disc. This gap should be
large enough so that the sandpaper does not rub against
the table, but small enough so that the gap is not a pinch
hazard.
Tools Needed:
Wrench 10mm ...................................................1
Ruler ..............................................................1
To set the table gap and parallelism, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen the six hex bolts that secure the table to the
table support brackets.
3. Adjust the table so that there is a
3
⁄16'' gap (Figure
17) between the disc (with sandpaper installed) and
the edge of the table along its full length.
4. When the miter slot is parallel with the sanding disc,
tighten the hex bolts.
5. Spin the disc by hand to check if the sandpaper
touches the table.
IMPORTANT: DO NOT turn the disc sander ON at this
point.
— If the if the sandpaper touches the table at
any point in its rotation, re-adjust the table
parallelism.
Figure 17. Table parallel with sanding
disc.
KfgM`\n
KXYc\
JXe[`e^;`jZ
*
Ð
(-