Filter
Top Products
Model W1828 (For Machines Mfg. Since 4/11)
-12-
SETUP
• Workbench Load: This machine distributes
a heavy load in a small footprint. Some
workbenches may require additional bracing
to support both machine and workpiece.
• Working Clearances: Consider existing and
anticipated needs, size of material to be
processed through the machine, and space
for auxiliary stands, work tables or other
machinery when establishing a location for
your sander (see Figure 4).
• Lighting: Lighting should be bright enough
to eliminate shadow and prevent eye strain.
MAKE your shop “child
safe.” Ensure that your
workplace is inaccessible
to children by closing and
locking all entrances when
you are away. NEVER allow
untrained visitors in your
shop when assembling,
adjusting or operating
equipment.
Cleaning Machine
The table and other unpainted parts of your
disc sander are coated with a waxy grease that
protects them from corrosion during shipment.
Clean this grease off with a solvent cleaner or
citrus-based degreaser. DO NOT use chlorine-
based solvents such as brake parts cleaner or
acetone—if you happen to splash some onto a
painted surface, you will ruin the finish.
Machine Placement
NEVER clean with gasoline
or other petroleum-
based solvents. Most have
low flash points, which
make them extremely
flammable. A risk of
explosion and burning
exists if these products
are used. Serious personal
injury may occur if this
warning is ignored!
ALWAYS work in well-
ventilated areas far from
possible ignition sources
when using solvents to
clean machinery. Many
solvents are toxic when
inhaled or ingested. Use
care when disposing
of waste rags and
towels to be sure they
DO NOT create fire or
environmental hazards.
3" Air
Gap
Min.
Duct
18"
17
1
/
4
"
Figure 4. Working clearances.