Filter
Top Products
Model W1828 (For Machines Mfg. Since 4/11)
-19-
OPERATIONS
Attaching Sandpaper
The Model W1828 sander uses 12" diameter pressure
sensitive adhesive-backed (PSA) sanding discs. These
are available in a variety of grits. The sandpaper can be
replaced without removing the table.
To attach the sandpaper disc, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Peel-off the old sandpaper, and clean the disc
surface with mineral spirits, and wipe dry.
3. Peel back the protective layer on one-half of the
sandpaper disc and fold it against the remaining
half.
4. Slip the half with the protective layer between the
disc and the table edge, as shown in Figure 14.
5. Position the exposed adhesive on the upper half of
the sandpaper disc over the aluminum disc above the
table. Once it is positioned evenly across the disc,
press the adhesive firmly onto the surface.
6. Now rotate the disc so the lower half is above the
table, peel-off the other half of the protective
paper, as shown in Figure 15, then press the
sandpaper disc firmly against the disc so adhesion is
complete.
Figure 14. Slipping covered sandpaper
between disc and table.
Figure 15. Removing the paper backing.