Filter
Top Products
5.
1. Opening the X-Bench
a
.
T
he X-Bench comes in the folded position and no assembly is
r
equired. In order to open the X-Bench, the user must pull and
twist the main knob, located by the handle, to the open position (Fig. 1a).
b. After the table has been opened, the knob must be turned back
into the locked position before extending the legs or placing the
table upright. To lock the table in place, twist the main knob back
into the closed position. Once the main knob is in the closed
position, the user can now safely extend the legs and then place
the table upright.
Table lock must be in the locked position, the
bench may collapse in use if not fully locked.
(Fig. 1b).
2. Extending the Legs
a.
Once the table is opened and the main knob is in the locked
position, the user can now extend the legs of the work station.
While the table is on its side or inverted, extend the legs completely
and make sure the leg braces are straightened and locked. The
pin will lock in place to ensure that the leg brace is fully secured
(Fig. 2).
3. Adjusting Leg Height
a
.
W
ith the table still on its side or inverted, the user can adjust the
t
able height to his/her preference. In order to adjust the table
height the user must:
b. Fully open the leg locking lever. By positioning the lever in the
open position (Fig. 3), it will allow the user to adjust the leg to a
d
esired height marked on the leg. After the leg is positioned at a
desired height, the user must close the lever locking mechanism to
half way and allow the pin to snap into the lock position. You can
visually make sure the pin is depressed correctly and ensure the
leg cannot slide at this point. (Fig. 4).
If the pin is not depressed into the hole, the leg clamp will be very
difficult to close. Damage may occur to the leg clamp if too much
force is applied without the pin being in the correct location.
Each leg lock pin must be fully engaged and
clamped fully closed before use.
Table may
collapse if leg locks are not secure..
Table must be level and stable for use. If the
lever does not close completely or is difficult to
depress, this means the pin is not in the correct location. You
MUST adjust the leg to position the pin into the correct height
marking (Fig. 5). Close the clamp fully with pin in hole before use.
Table must be level and stable for use.
WARNING
!
Fig. 1a
Pins are not
engaged in
hole, unit is
now open.
Fig. 1b
Pins are
engaged in
hole, the
table is now
locked.
Using Your X-Bench Work Station – No Assembly Required
Fig. 2
Pin is shown in the
locked position.
WARNING
!
Fig. 4
Pin is fully
depressed = leg
is locked in
position
Fig. 3
WARNING
!