Filter
Top Products
15. Shelf and Tool Bag (Sold Separately)
a.
Shelf and tool bag come fully assembled.
b. There are four hooks under the work bench (Fig. 23.)
c. Attach the Velcro straps located on the shelf to the hooks
under the table (Fig. 23).
Note: Unit can fold up with shelf and bag attached. Maximum
weight load is 20lbs.
13. Finishing Tray (Sold Separately)
a.
Locate the following parts:
(1) Knob, (1) Large washer, (2) U-brackets and (2) Screws.
Insert the tray into the three holes provided. From the back side
of frame thread large washer and knob into the middle hole in
tray until snug. (Fig. 24).
Do not over tighten the knob as it may damage
the plastic body.
b. Secure both sides of tray using the (2) U-brackets and screws
(Fig 25).
c. Remove the cup/tape dispenser by turning and matching the
shape (Fig. 26).
d. Remove and mount the paper towel dispenser into the vertical
slot Fig. 27. Maximum weight load is 10lbs.
14. Wedge Dog Supports:
a.
Two wedge dog clamps are included with your X-Bench
product. These wedge dogs are placed into the dog holes on
the surface of the X-Bench to hold pieces of wood during cutting.
The wedge dogs are capable of holding 1x and 2x material.
9
.
Fig. 23
Fig. 24
Fig. 22
CAUTION
!
Fig. 25
Fig. 26
Fig. 27
Direction
of Cut