Sparky Group BAR 12E Cordless Drill User Manual


 
Instruction Manual EN
7
Figure 2
Figure 3
IMPORTANT INFORMATION FOR
RECHARGING HOT BATTERIES
Whenusingyourcordlessangledrill/drivercon-
tinuously, the batteries in your battery pack will
becomehot.Youshouldletahotbatterypack
FRRO GRZQ IRU DSSUR[LPDWHO\  PLQXWHV EHIRUH
attempting to recharge. When the battery pack
becomes discharged and is hot, the red light on
WKHFKDUJHUZLOOÀDVK:KHQWKHEDWWHU\SDFNFRROV
down, the red light will glow continuously to indi-
cate fast charging mode, 1-hour charge time.
NOTE. Thiswilloccurwhencontinuoususeof
your tool causes the battery pack to become hot.
It does not occur under normal conditions.
VII - Know your product
212))VZLWFK
)RUZDUGUHYHUVHVZLWFK
3. Keyless chuck
4. Torque control collar
5. Battery
6. Charger
/('FKDUJHLQGLFDWRU
8. Spindle lock button
VIII - Operation
SWITCH OPERATION
1. When the trigger switch is depressed, the tool
rotates. When the trigger is released, the tool
VWRSVFig. 4
2. The rotation speed can be controlled by varying
WKHSUHVVXUHRQWKHWULJJHUVZLWFK/LJKWSUHV-
sure on the trigger switch results in low rota-
tion speed, further pressing results in smooth
increase of the rpm to maximum upon reaching
the extreme position.
Figure 4
INSTALLING AND REMOVING BITS
CAUTION: Switchoffthepowertool
prior to any procedure on it. To avoid involuntary
switching on we recommend removing the
battery pack.
3UHVVEXWWRQWRORFNWKHVSLQGOH
5RWDWHWKHFKXFNFROODUDQWLFORFNZLVHXQWLO
WKHMDZVRSHQVXIILFLHQWO\IRUWKHELWWREHLQ
-
serted.
3. Rotate the chuck collar clockwise to fasten the
chuck.
4. Ensure the bit is secured.
5HOHDVHEXWWRQ
7RUHPRYHWKHELWZLWKEXWWRQGHSUHVVHGURWDWH
the chuck anti-clockwise.
CAUTION:1HYHUSUHVVEXWWRQ
while the spindle is still rotating. Otherwise
this shall damage the tool and invalidate the
manufacturer’s warranty.
TIGHTENING AND LOOSENING SCREWS
Installthebitthatmatchesthescrew,lineupthe
bitinthegroovesoftheheadofthescrewthen
tighten it.
pages-BAR12E.indd 7 17.3.2006 . 09:11:20