Filter
Top Products
PG10 User Manual ◄ 11
OPERATING PROCEDURES
1. Observe all safety precautions.
2. Always start the grinder with the grinding wheel
away from the work surface by turning the hand
wheel counter clockwise to raise the wheel.
3. Move the hydraulic circuit control valve to the ON
position.
4. Squeeze the trigger momentarily. If the grinder does
not operate, the hoses might be reversed. Verify
correct connection of the hoses before continuing.
5. Start the grinder and move the grinding wheel to the
work surface by turning the hand wheel clockwise.
6. Grind a small amount of material at a time adjusting
the grinding wheel as necessary by turning the hand
wheel.
NOTE:
If the grinder is not loaded against a work surface
when the trigger is released, the wheel will take 5-10
seconds to come to a complete stop. Avoid uninten-
tional contact of the grinding wheel during the coast
down period.
COLD WEATHER OPERATION
If the grinder is to be used during cold weather, preheat
the hydraulic uid at low engine speed. When using the
normally recommended uids, uid temperature should
be at or above 50 °F/10 °C (400 ssu/82 centistokes) be-
fore use.
Damage to the hydraulic system or grinder can result
from use with uid that is to viscous or too thick.
OPERATION