Filter
Top Products
1. Move pusher to rear until latched.
2. Use stick of staples to move cover spring to one
side and drop over core of magazine.
Repeat until magazine is loaded, allowing
enough space for pusher to disengage from
the latch.
3. Depress pusher latch pin with thumb and
allow pusher to slide forward to engage
staples. On narrow crown models pull
pusher back out of notch and allow to slide
forward.
NOTE: Use only staples recommended by Stanley-Bostitch for the T40 Series staplers or staples which meet
Stanley-Bostitch specifications.
LOADING THE T40M TOOLS
-10-
FASTENER SPECIFICATIONS
STAPLE SERIES TOOL MODEL CROWN WIRE SIZE MAXIMUM LEG LENGTH
S2-16 Ga. T40S2 1.000 (25mm) .0625 (1.58mm) 1-1/2” (38mm)
S4-16 Ga. T40S4 1/2” (13mm) .0625 (1.58mm) 1-1/2” (38mm)
S5-17 Ga. T40S5 7/16” (11mm) .054 (1.37mm) 1-1/2” (38mm)
SX5035 T40SX 5/32” (4mm) .050x.035 (1.3x0.89mm) 1-1/4” (32mm)
S5-17 Ga. T40S5-SF 7/16” (11mm) .054 (1.37mm) 1/2” (13mm)
STAPLE TYPE
Wide Crown
Narrow
Crown
•
S2 & S4 Staples: 50 staples per stick; 3 sticks per load
•
S5 Staples: 56 staples per stick; 3 sticks per load
•
SX Staples: 100 staples per stick; 2 sticks per load
• All staples are galvanized finish.