Filter
Top Products
-7-
LOADING THE 651 STAPLER
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE shouldALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
t
ool. Eye protection is required to guard against flying fasteners and debris, which could
c
ause severe eye injury.
T
he employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
A
NSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
•Never place a hand or any other part of the body in nail discharge area of tool while
t
he air supply is connected.
•
Never point the tool at anyone else.
•
Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
•
Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE 651 SERIES STAPLERS:
1. Move pusher to rear until latched. Cover will open. Pusher will be held in place by a pin detent.
2. Drop staples over magazine and slide forward. Repeat until magazine is loaded.
3. Pull Pusher back slightly and depress pin detents. Allow pusher to slide forward over the pin detent.