Filter
Top Products
FASTENER DEPTH CONTROL ADJUSTMENT
Always disconnect air supply: 1) Before making adjustments; 2) When servicing the tool; 3)
When clearing a jam; 4)When tool is not in use; 5) When moving to a different work area, as
accidental actuation may occur, possibly causing injury.
The Fastener Depth Control Adjustment feature provides control of the staple drive depth from flush with or
j
ust above the work surface to shallow or deep countersink.
TO ADJUST THE FASTENER DEPTH CONTROL:
Disconnect tool from air supply before attempting any parts disassembly and before
changing the work contacting element adjustment.
1
) Loosen screw with 4mm hex key.
2) Move sliding shoe down (away from nose) to decrease the
d
rive depth or up (toward the nose) to increase the drive depth.
3
) Tighten screw with 4mm hex key
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS
MANUAL OBSERVE THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval from
BOSTITCH, INC.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or contact trip in an actuated position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legibleWARNING LABEL.
• Do not continue to use a tool that leaks air or does not function properly. Notify your nearest
Bostitch representative if your tool continues to experience functional problems.
-8-