Filter
Top Products
6
1. Open the magazine:
Pull pusher back to
engage the latch.
2. Load Nails:
Hold nailer down with
magazine tilted downward.
Insert stick of nails
3. Close Magazine:
Release pusher by first pulling back on
the pusher and then pressing the pusher
release tab. Slide pusher against nails.
NOTE: Use only nails recommended for use in Bostitch N88 nailers or nails which meet the
Bostitch specifications.
LOADING THE N88
EYE PROTECTION which conforms to ANSI specifications and provides
protection against flying particles both from the FRONT and SIDE should
ALWAYS be worn by the operator and others in the work area when loading,
operating or servicing this tool. Eye protection is required to guard against
flying fasteners and debris, which could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American
National Standards Institute, ANSI Z87.1-1989 (R1998) and provide both frontal
and side protection. NOTE: Non-side shielded spectacles and face shields
alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool
while the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
N88RH/WWB