Filter
Top Products
Windows - Installation Instructions-
8 Second Edition 96127
StorageTek Proprietary
Install Storage Manager components on to the host
Refer to the Storage Manager Installation Guide for Windows. Software
components are located on the CD that comes with the host attach kit.
Note: Before rebooting (as mentioned at the end of the Installation Guide
procedures), install the Fibre Channel cables as instructed in the
following section.
Install Fibre Channel Cable
Attach cables using the following procedures.
1. Route the fibre channel interface cables between the storage system and
the host or per your customer’s system configuration plans.
2. Attach the fibre channel cables to the INPUT connectors on the
controller’s host interface minihubs.
The following photograph shows the input side to the Control Module, showing
the 2 Gigabit LC to LC Fibre Channel (FC) shortwave (fiber-optic) cable.
Make sure that your minihub speed is set to correspond with your HBA and
switch speed. Also ensure that your host is attached to different controllers, as
shown below..
Note: Storage systems that use the model 28xx controllers will have host and
drive interface ports on the controller FRUs, as shown below. The left
FRU is Controller A and the right FRU is Controller B. Refer to the
Array Module manual for more information.
1
2
34
Host Minihub 1 and 3 are
supported by Controller A
Host Minihub 2 and 4 are
supported by Controller B