Filter
Top Products
www.tanaka-usa.com
5 contacttanaka@tanaka-ism.com
Owner’s Manual
TED-210/TED-262L/R/DH/HS
Starting
1. Set ignition switch (1) to (RUN) position. (Fig. 2-2, 2B)
*Push priming bulb (4) several times so that fuel flows through
the bulb or return pipe (5). (If so equipped) (Fig. 2-2C)
2. Set choke lever to (CHOKED) position. (Fig. 2-3, 3B)
3. Pull the recoil starter handle briskly, taking care to keep the
handle in your grasp; and not allowing it to snap back. (Fig.
2-4)
4. Once the engine is running, move the choke to the
run-position. (Fig. 2-3, 3B)
NOTE! At this stage if the engine does not start, repeat
procedure from 2 to 4.
5. After starting the engine, allow the engine about 2-3 minutes to
warm up before subjecting it to any load.