Filter
Top Products
www.tanaka-usa.com
7 contacttanaka@tanaka-ism.com
Owner’s Manual
TED-210/TED-262L/R/DH/HS
•
To tighten the chuck more securely, set a 19mm spanner (1) between gear case and drill chuck to
lock drive shaft. Turn on lock lever (2) first, then hit the mounted chuck handle with a hammer to screw
in (clockwise) the chuck. (TED-262L~262DH) (Fig. 2-6)
•
To loosen the chuck, set the spanner on the other side and hit the chuck handle from this side to screw
out (counterclockwise), the chuck with the lock lever on. (TED-262L/262DH) (Fig. 2-6B)
•
Note! In case of TED-262R, use chuck mount wrench (3) in place of chuck handle and tighten or un-
tighten manually instead of hitting. Do not hit the chuck mount wrench. (Fig. 2-7, 7B)
Stopping (Fig. 2-8, SB, SC)
Gradually decrease the engine speed to an idle speed, and then slide ignition switch (1) to STOP position.