Thomas & Betts 20 Battery Charger User Manual


 
Part No. 90-0123-00
Libertycombi.p65 10/26/98
10
LINK 2000
The Link 2000 has the same features as
the Link 1000, providing inverter/charger
control and complete battery state-of-charge
information. It monitors two battery banks.
OPTIONAL REMOTE CONTROL PANELS
Remote Control Panel
An optional remote control panel is
available. The LED bargraphs on the remote
control panel shows battery voltage and DC
current in both inverter and charger modes.
Easy to see red, yellow and green LEDs
show the battery state-of-charge. Power
Sharing, charger ON/OFF, inverter ON/OFF
controls are provided. Set up features include
selection of Idle Threshold, Battery Type and
Battery Capacity.
Advanced Remote Control Panels
Link Instrument
Advanced remote control panels are also
available: the Link 1000, 2000 and 2000R.
LINK 1000
Link 1000 controls the Freedom Inverter/
Charger and provides complete battery
state-of-charge information including DC
voltage, current, Amp-hours consumed, Time
Remaining and historical data for a single
battery bank.
LINK 1000
LINK 2000
LINK 2000R
The Link 2000R adds the ability to
regulate an engine-driven alternator. The
precision regulator in the LINK 2000R allows
the alternator to be controlled as a 3-stage
battery charging system.
If Link Instrument is used to control the
inverter/charger, refer to the Link Owner’s
Manual for setup and control information.
The jumper is not installed in the AUX
Switch Port on the front panel of the
inverter when the Remote Control Panel
or Link Instrument is used. See page 23
for more details.
Refer to the Remote Control Panel
or LINK Owner’s Manual for
installation and operation instructions
Remote Control Panel